Capulet
WiFi DC Dimmer (Discontinued)
- WiFi DC dimmer pack
- Designed for easy incorporation into costumes and props
- Accepts both ArtNet and sACN control
- Controls 12 output channels of LEDs or DC loads, including EL wire, motors and MR16s
- Available with JST connectors or pluggable screw terminals
Specs
The Story
An updated version of our original Capulet system, the Capulet 2.0 is a 12-channel ArtNet or sACN-controlled WiFi DC dimmer pack. Specifically designed to be easily incorporated into a costume, it can also be used in a variety of other situations where low voltage DC dimming is needed. With a maximum input voltage of 12.5V, the Capulet can easily control 12 channels of LEDs or LED tape, EL wire, motors, MR16 lamps, or a variety of other DC loads.
A note on running ArtNet or sACN over Wifi:
As performance wireless goes, it’s not a perfect solution. WiFi is subject to a lot of interference from guest cell phones, other 2.4GHz solutions, and other WiFi access points. However, sometimes it’s all you’ve got, so we’ve built this solution for those cases where occasional signal loss or interference is acceptable.
Product Details
SPECS
- Size: 2.75” x 2” x 0.8”
- Runs on 5V to 12VDC
- Two connector options:
- 2mm JST connectors: 2A per input, 2A per channel
- 3.5mm pluggable screw terminals: 8.3A per input, 3-5A per channel
- Approximately 1500Hz PWM
- WiFi-based, 802.11 b/g/n, supports WPA2 PSK mode
FEATURES
- 12 channels of output, fed from two separate power inputs
- 8-bit or 12-bit channel control (1 or 2 DMX slots per channel)
- Internally hosted web based configuration
- Static IP or DHCP support
- Accepts ArtNet and/or sACN control
Gallery
Case Studies & Testimonials
JESSICA RAJKO-ART INSTALLATION
